This is a 40 mm artificial soccer turf with a polyethylene pile and a PP + net + SBR latex backing, supplied in rolls and installed as a non-filled system. Nothing is spread into the pile after installation: the surface the players run on is the surface that leaves the factory.
That one design choice shapes everything else. A filled field leans on a deep layer of sand and rubber to hold the yarn upright and soften landings. A non-filled build has to reach the same stability through the yarn itself, the tufting and the stiffness of the backing, which is why the backing here is a three-layer laminate rather than a single coating, and why the pile is brushed upright at the end of installation instead of being buried.
Non-filled describes the surface build, not a shortcut on the ground beneath it. The base, the edge restraints, the seams and the line marking are all still part of the job, and the field is still maintained — the difference is what sits between the boot and the backing.
Most enquiries for this model arrive with a tender that names a 40 mm pile and either leaves the infill open or asks for a non-filled build outright. If your document was written around a filled system, say so early: the pile, the backing and the base can still work, but the specification should be adjusted before anything is ordered. As an artificial soccer turf supplier we would rather settle that at enquiry stage than after the container has sailed.
Non-Filled Playing System
No sand or rubber to buy, spread or top up. A filled pitch loses infill to boots, wind and drainage every season and has to be replenished. This non-filled soccer artificial grass holds its pile with tufting and backing alone, so the annual infill order, the spreader and the levelling work drop out of the maintenance budget.
Cleaner everywhere around the pitch. There is nothing loose to walk into changing rooms, wash into gullies or blow into neighbouring gardens, which is usually the argument that settles the decision on school and municipal projects.
A shorter installation. Spreading, brushing in, compacting and topping up infill is a stage this build simply does not have, so there is less site time and less equipment on the ground before handover.
Tighter underfoot. With no loose layer between boot and backing, the surface feels firmer and direction changes feel quicker. Players also notice less of the deep, slow give that a heavily infilled field has — a trade-off worth judging on a sample before a full pitch is committed.
Even behaviour as it ages. Infill can ridge, hollow and migrate across a field; without it, the ball travels the same way across the whole pitch season after season, which is the consistency most buyers of artificial grass for soccer are trying to protect.
If your specification still calls for infill. Some tender templates are copied from filled-field documents. Send us the clause before you commit and we will confirm what this yarn and backing can accept for your project.
Yarn, Backing & Play Character
Polyethylene yarn. PE is the softer of the two common face yarns. It stays flexible in cool weather and is less brittle than a stiff polypropylene pile, which is why it is used here rather than PP alone.
Pile that stands back up. The yarn is brushed after installation and again after heavy use; the heavier the pile, the better it resists matting, and brushing is the habit that keeps the surface looking new.
A laminated backing rather than a single coat. The net layer carries the tufts, the latex bonds them and holds the roll flat, and the polypropylene gives the sheet its dimensional stability — the combination that keeps seams closed when temperatures swing between seasons.
Wet-weather behaviour. Rain does not swell the backing or lift the yarn. Water runs through the surface to the base and away along the fall, so a pitch is playable after heavy rain rather than postponed.
Seams and edge fixings do the holding. With no infill weighing the surface down, the joints and the perimeter carry the load; a well-bonded seam on a properly restrained edge is what keeps the field flat for its whole life.
What to compare. Two rolls can both read 40 mm and still be very different products. When offers come from more than one soccer field turf manufacturer, put pile weight, density, yarn and backing side by side on the same basis before looking at the headline figure.
Site Preparation & Installation
Strip and check the subgrade. Take off the old surface, inspect the levels and look for soft spots. On an artificial turf soccer field the base carries the whole system, so any weak area is repaired before a single roll is unloaded.
Build the base and the fall. Compacted crushed stone over a geotextile, topped with a fine binding layer, kept true to level with a fall running towards the drainage line. Small undulations show through a 40 mm pile once it is brushed up. Where indoor artificial grass turf is being laid over an existing sports floor, the stone work is replaced by a check that the floor is flat, dry and sound before any underlay goes down.
Fix the edge restraints. Concrete kerb, timber edging or a purpose-made profile around the whole perimeter — this is what holds the turf under tension and keeps the seams closed.
Set out the pitch and the lines. Measure the playing area plus the run-off the sport requires, check the diagonals until the rectangle is square, and run string lines for every marking before anything is cut.
Roll out and let the pile relax. Unroll in the same direction across the whole field so pile and colour read evenly, and give the turf time to settle before trimming.
Cut, join and fix. Overlap adjoining rolls, cut through both layers for a clean joint, bond the seam on joining tape and fix the perimeter into the edge restraint.
Brush the pile up. A rotary brush lifts the yarn flattened by the roll. This is the stage that turns a flat green sheet into a pitch, and it is worth doing again after the first week of use.
Mark the lines and hand over. Lines go in either as inlaid strips cut into the surface during installation or as painted markings applied after brushing. Decide which route your project uses before the turf is cut, because it changes the cutting plan.
Applications & Venues
School and community pitches
Most of these rolls end up on a fenced pitch serving a school, a housing estate or a district sports ground — a surface used every day by mixed ages rather than on match days only. A 40 mm pile gives enough depth for sliding and falling without the upkeep a filled field needs, and the crew that looks after the building can look after the pitch as well.
Multi-use courts and halls
With nothing loose on the surface, the same carpet works where football shares the space with basketball, pickleball or hockey practice. Indoor artificial grass turf is a growing part of this: sports halls and covered training centres use it for futsal and warm-up areas where granules would be walked through the building.
Renovation and replacement
When an artificial turf soccer field reaches the end of its life, the question is usually whether to rebuild with infill again. Operators who have spent years clearing granules out of drains and replacing lost rubber often move to a non-filled build for the replacement, keeping the existing base where it still meets specification and renewing only the surface.
Distributors and contractors
Buyers ordering wholesale soccer field turf for a region tend to carry one non-filled model alongside a filled one, so they can answer either specification without starting a new development cycle every time a tender lands.
Specifications
Product type
40 mm artificial soccer turf, non-filled system
Pile height
40 mm
Yarn material
PE (polyethylene)
Pile weight
10,000 D
Density
10,500 lbs
Backing
PP + net + SBR latex
Infill
None required
Colour
Customized to order
Supplied form
Rolls wound on cores, labelled per roll
Typical use
Football pitches, multi-use courts, indoor halls
Handover, Care & Maintenance
Handover
Walk the finished surface before signing anything off. Check that seams sit flat and closed, that the lines measure true to the drawing, that the perimeter is fixed hard against the edge restraint and that no wrinkles have lifted overnight. Run water over a section and watch where it goes: it should reach the drainage line without pooling in the middle of the pitch. Photograph the field empty and keep the as-built notes with the roll labels — both are useful years later if a section ever needs replacing.
Routine care
A non-filled soccer artificial grass surface asks for less than a filled one, but not for nothing. Brush the pile after heavy use and a few times across a season so the yarn stands up and the colour stays even; clear leaves and litter before they mat into the pile; and keep the gullies and outlets free, since drainage is the one thing that fails quietly. There is no infill to top up, redistribute or replace, which removes the most frequent job on a filled field.
Stains and repairs
Spot-clean with water and a mild detergent and rinse well; stubborn marks and chewing gum come away more easily while they are fresh. Keep vehicles off the surface, avoid metal shovels when clearing snow or debris, and check the seams and edge fixings once a year. Small damaged areas can usually be cut out and patched, which is a good reason to keep a metre or two of artificial grass for soccer from the same production batch in store.
Ordering, Packing & Delivery
Minimum order. 2,000 sqm (one container).
Indicative price. USD 2.50–5.50 per square metre for this model; the figure for your project is confirmed in the quotation once specification, quantity and destination are fixed.
Production time. 7–15 days production, counted from confirmation of the order and the final specification.
Shipping. About 30 days by sea; actual transit varies with the sailing schedule, destination port and customs clearance at your end.
Packing. Rolls are wound, strapped and labelled with the model and roll length, then loaded so they travel without flattening the pile. Tell us if your warehouse needs pallets or a particular label format.
Mixed loads. This model shares a container easily with the rest of the range — the 45 mm soccer field turf QS071, the 45 mm sport outdoor turf QS070, the 10 mm golf durable artificial grass QS072 and the 8 mm soft putting green QS073 — which is how most wholesale soccer field turf orders for distributors are put together.
Warranty. Five years on this model, stated on the order confirmation.
Payment and delivery terms. Agreed with your sales contact and written into the order confirmation.
Specification lock. Before production, pile height, yarn, backing and colour are written onto the order confirmation and matched against the approved sample — the same basis any careful soccer field turf manufacturer works to.
Colour sign-off. Colour is customized to order; ask your sales contact about sample availability and approve the colour against a physical reference before production begins.
What to send with an enquiry. The playing area and run-off dimensions, whether lines are inlaid or painted, your colour reference, the destination port and any tender clause on backing or drainage. Those five items let an artificial soccer turf supplier price the job without a week of back-and-forth.
Quality Control & Inspection
Working as an export specialist from Nantong, Jiangsu, we build quality checks into every stage of an order rather than leaving them to the end. Before bulk production, yarn, colour and backing are confirmed against the approved sample; during production we check pile height, density, tufting and backing at the supplier; before loading, rolls, colours and packing are checked again and the inspection record is shared with you. If you prefer an independent eye, we can coordinate third-party inspection such as SGS or BV, book the visit and follow up on any defects found. Faulty rolls are replaced or credited before shipment, and each carton leaves with its packing list and inspection sheet.
FAQ
Is 40 mm the right pile height for adult football, or only for schools?
Both. 40 mm is a working height for amateur and training pitches as well as school grounds — enough pile for sliding and ball control without the maintenance a deeper filled field brings. Where a brief calls for a showpiece stadium surface with a heavy infill specification, the deeper models in the range are the better fit; for daily community and school use, this 40 mm artificial soccer turf is the more practical choice.
What does non-filled soccer artificial grass feel like to play on?
Firmer than a heavily infilled pitch underfoot, with quicker direction changes and a very even ball roll. Players notice the difference in the first ten minutes and stop noticing after that. If the feel matters to a committee, judge it on a sample rather than on a description — that is the only way to compare it honestly with the field you are replacing.
Can the same turf be used for indoor and outdoor pitches?
Yes. The backing does not soften in rain and the pile is unaffected by being under cover, so the same roll works in a sports hall or covered training centre as well as outdoors. What changes is the base: outdoors it is a drained stone build, indoors it is a flat, dry sports floor with a suitable underlay. Indoor artificial grass turf also removes the one outdoor job that never ends — clearing the surface of leaves and debris before a session.
How much turf do we need for a full artificial turf soccer field?
Send the playing area plus the run-off your sport's rules require, and we will work the roll plan from there. A full artificial turf soccer field is normally laid in one direction with as few seams as possible, so roll length and width decide how much waste the plan carries. With the dimensions we come back with a cutting plan rather than a bare area figure.
Does artificial grass for soccer get too hot in summer?
Any synthetic surface runs warmer than natural grass in direct sun, and this one is no exception. In practice it cools quickly once shaded or watered, and most schools schedule around the middle of the day in high summer. If heat is a real concern on your site, raise it at enquiry stage — yarn colour and the amount of shade around the pitch both make a difference.
Can you match our club colours?
Colour is customized to order, so send the reference you want to work to. As an artificial soccer turf supplier we match against a colour reference you approve before production starts, and we recommend approving it on a physical swatch rather than on screen, where lighting changes everything. Ask your sales contact about sample availability for a custom colour.
How does this compare with the 45 mm filled models in your range?
The 45 mm models carry a deeper pile and are normally installed with infill, which gives a softer, slower surface underfoot; this one is shorter, firmer and needs no infill at all. Both sit inside the wholesale soccer field turf range we supply for school and club work, and the choice usually comes down to how the pitch will be maintained rather than to how it plays on the first day. When a soccer field turf manufacturer quotes both, ask for pile weight, density and backing side by side — those three figures tell you more than the headline number.